Guns & Outdoors Forum

CPJ 2.0 wrote: ↑Sun Mar 30, 2025 3:17 pm This thread needs more aluminum!

Gayest Hipoint .270 ever.
Sayin.

Gila wrote: ↑Mon Mar 31, 2025 1:05 am

CPJ 2.0 wrote: ↑Sun Mar 30, 2025 3:17 pm This thread needs more aluminum!

Gayest Hipoint .270 ever.
Sayin.

So you do realize that even though the forum software showed your Charger, that I was quoting another post about a *mustang, and referred to IT as gay, right? (Hint, your car isn’t a mustang)

My Mowrey rifle in 32 cal, and a raccoon taking a nap.

Not a great picture but here’s my Ruger New Vaquero 3.5” Birdshead in .45 acp with Moose stag grips.

Awe man the moose is loose!

CPJ 2.0 wrote: ↑Mon Mar 31, 2025 2:12 am

Gila wrote: ↑Mon Mar 31, 2025 1:05 am

CPJ 2.0 wrote: ↑Sun Mar 30, 2025 3:17 pm This thread needs more aluminum!

Gayest Hipoint .270 ever.
Sayin.

So you do realize that even though the forum software showed your Charger, that I was quoting another post about a *mustang, and referred to IT as gay, right? (Hint, your car isn’t a mustang)

Not a Charger either...

Dodge guys hate when you misgender their cars.

CPJ 2.0 wrote: ↑Mon Mar 31, 2025 11:03 am Dodge guys hate when you misgender their cars.

Especially the Dart drivers.

OMG! After a few head butts with my dad when I was sixteen he sold my sports car and bought me a freaking brown Dart with a tan vinyl top and an in-line six cylinder. 0-60 within the same day, if you had a tail wind. I’m pretty sure he wanted to make sure. Never got laid again…

I made sure that car was DRT within 6 months…

I know it’s a gun porn but these two holsters just came in so I thought I’d throw them in. Both of them relatively rare but they pop up on eBay here and there.

This one if from the old Guns and Ammo writer and Old West guns and hear expert Phil Spangenberg’s shop in Tombstone A.T. This one is from Tombstone Leather. I think they had John Bianchi Frontier Leather make their stuff for them because they are basically identical.

There are guns in the leather so it works

It should be obvious to even the most uninitiated observer by now why there is a shortage of quality buckhorn pistol grips

This thread needs an ugly gun

Ok

She is ugly but she sure performs!

Wambli Ska wrote: ↑Thu Apr 10, 2025 5:00 am Ok

IMG_1814.jpeg

Beating up a Glock like that I understand. But, a Sig?

Diver43 wrote: ↑Thu Apr 10, 2025 1:05 pm
Beating up a Glock like that I understand. But, a Sig?

IIRC, it was a basket case when E got it, he just didn't restore it to "like new"

GrapeApe wrote: ↑Thu Apr 10, 2025 2:13 pm

Diver43 wrote: ↑Thu Apr 10, 2025 1:05 pm
Beating up a Glock like that I understand. But, a Sig?

IIRC, it was a basket case when E got it, he just didn't restore it to "like new"

Yep, that. This gun was lost in the woods for a few years and then found again and it was a mess half buried in dirt. The owner gave her to me as a lost cause to use it as a demo gun in my classes.

After I cleaned it I managed to get ONE shot out of her before she gave up the ghost with the original parts. But it was dead center X at 10 yards. So instead of using her as a demo gun for my classes I decided to rebuild her.

Whoever thinks aluminum doesn’t corrode hasn’t seen something like this. The springs and a few trigger system parts were gone and the frame and slide too pitted to restore to new. So I cleaned her, replaced the broken stuff with eBay parts and then after getting her shooting again decided to have some fun with it and make it into my Dead pool gun. And yes she was a shooter!